What are the different sized steps available from Yeti Steps?

Yeti Steps are available in three sizes: WS225, WS285, and WS375, with centre-to-centre distances of 225mm, 285mm, and 375mm respectively.

What tools and materials are needed for the installation of Yeti Steps?

Required tools include a tape measure, marker, quality SDS Hammer Drill, 28mm SDS Plus 4 Cut Drill Bit, mallet, and optionally, epoxy resin.

What is the maximum factory-tested pull out resistance of Yeti Steps without epoxy?

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

Can epoxy resin help to achieve a higher pull out strength?

By adding epoxy resin during installation, Yeti Steps can achieve up to 1500kg pull out resistance, especially recommended if the concrete’s integrity is questionable or higher pull out strength is required.

What makes Yeti Steps easier to install compared with other steps on the market?

Yeti Steps offer a fast and clean installation process without the need for epoxy, thanks to their optimized expander leg design for superior anchoring.

How is the durability and safety of Yeti Steps ensured?

The steps incorporate a centralised high tensile 16mm steel bar, a high-strength 28mm diameter step leg, and optimised slip resistance, all designed to meet and exceed AS standards.

What technical specifications make Yeti Steps stand out?

Features like the stopper on the leg for installation to AS standards, high strength step support for extra rigidity, and full 360-degree pullout resistance underscore their quality and innovation.

How do Yeti Steps address slip and chemical resistance?

They have an optimised slip resistance pattern suitable for work boots and a chemical-resistant centralised steel bar, ensuring safety and durability in various environments.

Are Yeti Steps strong enough to hammer into position?

Installers will notice a significant improvement in design and material quality compared to competitors, evident from the moment they handle a Yeti Step. Yeti Steps are designed for the installer, they are made to be robust and handle being knocked into position without effecting the structural integrity or performance of the steps.

How to Install Yeti Steps

Follow this guide to install Yeti Steps so they are safe and secure.

What you need:

Tape measure and marker.
Quality SDS hammer drill.
28mm SDS plus 4 cut drill bit.
Mallet.
(Optional) Epoxy resin.

Step 1.

Mark and drill hole positions as per step width above. Be careful to keep the drill perpendicular to the pit wall.

Pre-drill using a smaller SDS bit for increased accuracy.

Step 2.

Clean dust from hole before
proceeding to next Step*.

Step 3.

Use a mallet to tap the step into holes; alternate the ends of the step with each knock. Only hit steps at each end, not in the middle.

Step 4.

Once the stoppers on the legs of the Yeti steps come into contact with the wall the step is installed and ready to use.

* Yeti Steps have been factory tested to achieve a pull out resistance of up to 500kg with no epoxy. If the integrity of the concrete or holes is questionable or a higher pull out strength is required then Epoxy resin can be added at this stage to achieve up to 1,500kg pull out resistance.